Posted By |
Discussion Topic: Diesel heaters
Similar Threads That Might Help :
Diesel Heaters - But Which Type ????|
Advice on fitting a diesel heater|
Advice on fitting a diesel heater|
Advice on fitting a diesel heater|
Wanted - Webasto/Eberspacher diesel heater|
-- Page:
1
2
3
4
5
6
7
|
|
palmtree |
|
Forum Regular
Posts: 298
Joined: Feb 2005
Add To Ignore List
|
I think the pump is low pressure output and just drips the diesel onto a hot wire mesh atomizer in the heater it vaporizes and then burns. Therefore the fuel line clips found by Pulse are fine and are also the type of clamps supplied by the makers of the heaters. Ian
|
annville |
|
Lives to Post
Posts: 1477
Joined: Oct 2013
Add To Ignore List
|
Hi Ian yes fuel supply to diesel heaters of Eberspacher, Webasto type etc are low pressure,as is the supply from fuel tanks to pumps, high pressure FUEL supply must be by pipes with a nut and olive connection, these aren't any more leak proof than rubber hose with clamp BUT are safer as not able to come undone under pressure and flood engine room with fuel. John
|
palmtree |
|
Forum Regular
Posts: 298
Joined: Feb 2005
Add To Ignore List
|
John/Annville, in my limited experience of Diesel heaters (the subject of this topic) i have never seen a high pressure fuel supply to them. Can you explain the type of marine heater that uses one? Thanks Ian
|
annville |
|
Lives to Post
Posts: 1477
Joined: Oct 2013
Add To Ignore List
|
Hi Ian Not of hand those that are high pressure the high pressure side would be part of the heater in side the heater, if the supply from the pump is high it would have a olive & nut connection, otherwise ie Eberpacher/Webasto/Hurricane and Kubola a hose and clamp supply would be normal, installation instructions should clarify this. John
|
ADI |
|
Been Posting For a Long Time
Posts: 2204
Joined: Oct 2009
Add To Ignore List
|
Hi just wondering what sealant to use on the exhaust pipe to seal it to the heater and skin fitting? how about this geocel-trade-mate-plumber-flue-silicone-black
Regards Adrian Michelle Beck Braydon and Mere.
|
Greybeard |
|
Forum Regular
Posts: 162
Joined: Sep 2021
Add To Ignore List
|
I never used any sealers, but you must use high quality clamps, stainless "mikalor" are very good, they have a saddle that clamps evenly around the entire fitting making a gas tight seal. the cheap screw clamps that are supplied with some heaters are not fit for purpose, except for the hot air side.
my appearance is down to me, my attitude is down to you.
|
annville |
|
Lives to Post
Posts: 1477
Joined: Oct 2013
Add To Ignore List
|
Hi Adrian yes that would be ok , Why do you need a sealant not usually needed, there should be a tight fit between hose and hull fitting with a clamp there to stop it coming of, there isn't any pressure as exhaust gas is just blowing through to atmosphere the hose needs to point/slope downwards at the fitting to stop/allow water to run outside and not back to heater. John
|
ADI |
|
Been Posting For a Long Time
Posts: 2204
Joined: Oct 2009
Add To Ignore List
|
Oh okay I just thought with Co2 its best to be belt and braces, but yes it is a snug fit so when clamped should be ok.
Regards Adrian Michelle Beck Braydon and Mere.
|